Differences

This shows you the differences between two versions of the page.

--- 3dprint:solidoodle [2019/02/09 11:26] – [Table] philpem
+++ 3dprint:solidoodle [2020/08/21 13:11] – [Current setup] philpem
@@ Line 23: / Line 23: @@
     * Keenovo 120W silicone bed heater element with internal thermistor
     * [[https://www.thingiverse.com/thing:104817|Cable chain]] and [[https://www.thingiverse.com/thing:118182|belt guard]]
-    * [[http://tomhorsley.com/hardware/solidoodle/solidoodle-ydirect.html|Y-axis direct-drive mod]] (3D model on [[http://www.thingiverse.com/thing:593006|Thingiverse]])
+    * [[http://tomhorsley.com/hardware/solidoodle/solidoodle-ybearing.html|Y-axis bearing support with SFL686ZZ flanged bearing]] and [[http://tomhorsley.com/hardware/solidoodle/solidoodle-ydirect.html|Y-axis direct-drive mod]] (3D model on [[http://www.thingiverse.com/thing:593006|Thingiverse]])
+      * Massively reduces Y-axis binding (especially after the bushings have started to wear)
     * [[https://www.thingiverse.com/thing:85707|Lawsy extended filament guide]]
-    * http://tomhorsley.com/hardware/solidoodle/solidoodle-ybearing.html -- Y-axis bearing support with SFL686ZZ flanged bearing
-      * Massively reduces Y-axis binding (especially after the bushings have started to wear)
   * Next additions:
     * [[https://www.thingiverse.com/thing:1443926|Belt clamps]] to reduce the risk of the Y-belt breaking at the screw-holes
@@ Line 56: / Line 55: @@
   * X: new motor 150mN.m vs. original 134mN.m
   * Y: new motor 480mN.m vs. original 212mn.m
+New motors awaiting installation:
+  * Z-axis: Precision Maker MTR-N17-48, NEMA-17. 1.8-degree (200 step). 3.4V 1.7A, 520 mN.m
 ===== Board configuration =====