Differences

This shows you the differences between two versions of the page.

--- hamradio:mmdvm:pog [2019/08/14 02:17] – philpem
+++ hamradio:mmdvm:pog [2019/08/14 02:31] – [In-system re-flash] philpem
@@ Line 30: / Line 30: @@
 It should now be possible to upgrade the board's firmware using the tools included with Pi-Star.
+To flash manually:
+<code>
+stm32flash -v -w mmdvm_hs_dual_hat_fw.bin -g 0x0 -R -i 20,-21,21:-20,21 /dev/ttyAMA0
+# -v: verify writes
+# -w: write flash from file
+# -g: start execution at specified address (after loading)
+# -R: reset device at exit
+# -i: GPIO sequence --
+#       enter with GPIO20 high and toggle GPIO21 L->H
+#       exit with GPIO20 low and GPIO21 H
+# /dev/ttyAMA0: Pi serial port
+#
+# default baud rate is 57600
+</code>