hamradio:mmdvm:setup

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

hamradio:mmdvm:setup [2019/08/14 01:15] (current)
philpem created
Line 1: Line 1:
 +====== MMDVM setup on a Pi ======
 +
 +This is intended mostly as an aide-memoir to myself -- your mileage may vary!
 +
 +  * Image the Pi's SD card with Raspbian.
 +  * Mount the ''​boot''​ partition and edit ''​cmdline.txt''​
 +    * Remove ''​console=serial0,​115200''​
 +    * Save
 +  * Edit ''​config.txt''​ and add the following to the end of the file:  <​code>​enable_uart=1
 +dtoverlay=pi3-disable-bt</​code>​
 +    * This disables the Bluetooth module and enables the UART for MMDVM use.
 +  * Unmount the partitions and fit the SD card to the Pi -- __do not fit the MMDVM POG board yet!__
 +  * Boot the Pi
 +  * When the Pi boots, log in (username ''​pi'',​ password ''​raspberry''​)
 +  * Enter the following commands:
 +    * <​code>​sudo systemctl disable serial-getty@ttyAMA0.service
 +sudo systemctl disable hciuart</​code>​
 +    * This disables the serial console and Bluetooth
 +  * Shut down the Pi and install the MMDVM POG board.
 +  * Boot the Pi and install the MMDVM software.
  
  • Last modified: 2019/08/14 01:15
  • by philpem